55T Tadano
55T Tadano GT550E CRANE
GT550E CRANE
- WORKING RANGE
- RATED LIFTING CAPACITIES
- DIMENSION
TELESCOPING MODE
1. Rated lifting capacities shown in the table are based on the condition that the crane is set on firm ground horizontally. Those above
bold line are based on crane strength and those below, it is stability.
2. Rated lifting capacities in the stability area comply with part 2 / ISO 4305.
3. The mass of load handling devices such as hook blocks {570 kg for *55 ton capacity, 410 kg for *35 ton capacity, 400 kg for *20 ton
capacity and 130 kg for 4.5 ton capacity} and slings, shall be considered part of the load and must be deducted from rated lifting
capacities.
4. Without front jack extended, when the boom is within the Over-front, Rated lifting capacities are different from those for the boom in the Over-side and Over-rear.
5. Standard number of parts of line for each boom length is as shown below. Load per-line should not surpass 42.2 kN {4,300 kgf} for
main winch rope and 44.1 kN {4,500 kgf} for auxiliary winch rope.
*: Optional
**: With single top (When the lifting capacities is 55,000 kg)
6. Special weather caution: Refer to the operation and maintenance manual.
7. For rated lifting capacity of single top, subtract the main hook mass from the relevant boom rated lifting capacity. Rated lifting capacity of single top should not exceed 4,500 kg.
8. Load radius shown in the table includes the deflection of the boom. Therefore, perform it according to the load radius. However for the jib operation, perform it according to the boom angle regardless of the boom length. The load radius shows reference value when the jib is attached to the 42.0 m boom, 38.1 m boom (Telescoping mode ) and 34.3 m boom (Telescoping mode ).